# \[868LP\] no lifesigns from serial port

**URL:** <https://forums.digi.com/t/868lp-no-lifesigns-from-serial-port/17363>\
**Category:** XBee & XBee Gateway\
**Tags:** 868lp\
**Created:** [September 8, 2016, 10:21am UTC](https://forums.digi.com/t/868lp-no-lifesigns-from-serial-port/17363 "2016-09-08T10:21:27Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![El\_Berto](https://avatars.discourse-cdn.com/v4/letter/e/bbce88/32.png) [@El\_Berto](https://forums.digi.com/u/El_Berto)\
**Post date:** [September 8, 2016, 10:21am UTC](https://forums.digi.com/t/868lp-no-lifesigns-from-serial-port/17363/1 "2016-09-08T10:21:27Z")

</div>

Hi to all,  
I’m trying to use Xbee 868LP module.  
As reported on XBIB-U schematics (and 868LP user guide) I made my OEM board:

- DIN (pin 4) to TX of FT232
- DOUT (pin 3) to RX of FT232
- RTS (pin 29) pull-down resistor (why reported on XBIB-U as output?
- CTS (pin 25) float
- RESET (pin 6) pull-up resistor to 3,3V
- PIN\_SLEEP (pin 10) pull-down resistor to GND
- ON (pin 26) present 3,3V

Using HyperTerminal (9600, 8-N-1) I get no answer from module anyway.

sending "+++  
" and "AT  
" no answer.  
Using XCTU I don’t detect module.

What am I missing?  
Thanks.

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [September 8, 2016, 10:55am UTC](https://forums.digi.com/t/868lp-no-lifesigns-from-serial-port/17363/2 "2016-09-08T10:55:53Z")

</div>

First off there is no after ending the +++. You simply wait for 1 second of silence, followed by +++ sent within 1 second. Followed by one second of silence. The radio will respond with an OK once command mode has been entered.

You might want to look again at the schematic. /CTS is not left floating. /CTS is connected through.
