# AnywhereUSB5 can not be configured

**URL:** <https://forums.digi.com/t/anywhereusb5-can-not-be-configured/12407>\
**Category:** USB\
**Tags:** anywhereusb\
**Created:** [January 17, 2014, 8:43am UTC](https://forums.digi.com/t/anywhereusb5-can-not-be-configured/12407 "2014-01-17T08:43:01Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Ph-Alcatel](https://avatars.discourse-cdn.com/v4/letter/p/85f322/32.png) [@Ph-Alcatel](https://forums.digi.com/u/Ph-Alcatel)\
**Post date:** [January 17, 2014, 8:43am UTC](https://forums.digi.com/t/anywhereusb5-can-not-be-configured/12407/1 "2014-01-17T08:43:01Z")

</div>

I see the device into “AnywhereUSB Remote Hub Utility” but I never have access to the Configure button (in Connect and Disconnect state).

So I tried with Telnet to change the IP settings.  
With the command “set network”, I see that I changed the “Stored configuration” but never the “Currently in use by the network stack”.

Is there any WebUI with this device? I can’t open it.

---

<div class="post-metadata">

**Author:** ![halovapor](https://avatars.discourse-cdn.com/v4/letter/h/54ee81/32.png) [@halovapor](https://forums.digi.com/u/halovapor)\
**Post date:** [January 17, 2014, 9:26am UTC](https://forums.digi.com/t/anywhereusb5-can-not-be-configured/12407/2 "2014-01-17T09:26:33Z")

</div>

The AnywhereUSB/5 Gen 1 does not have a web interface. You should be able to click the Configure button to set the ip address settings. The AnywhereUSB/5 Gen 2 has a web interface. The AnywhereUSB/5 Gen 2 with the 1.38 firmware and later, the Configure and Reboot button have been disabled. You must use the web interface or device discovery to configure the ip address settings.

[http://www.digi.com/support/kbase/kbaseresultdetl?id=3290](http://www.digi.com/support/kbase/kbaseresultdetl?id=3290)

Here is a link to the AnywhereUSB installation guide that should help you further if needed:

[http://ftp1.digi.com/support/documentation/90001085\_G.pdf](http://ftp1.digi.com/support/documentation/90001085_G.pdf)

---

<div class="post-metadata">

**Author:** ![Ph-Alcatel](https://avatars.discourse-cdn.com/v4/letter/p/85f322/32.png) [@Ph-Alcatel](https://forums.digi.com/u/Ph-Alcatel)\
**Post date:** [January 22, 2014, 5:34am UTC](https://forums.digi.com/t/anywhereusb5-can-not-be-configured/12407/3 "2014-01-22T05:34:26Z")

</div>

Thanks for your answer.  
I finally found that a proxy filtered the WebUI.  
Now with the WebUI access, the IP configuration is well applied and so the issue is resolved.