# API Tx frame to certain Node Identifier?

**URL:** <https://forums.digi.com/t/api-tx-frame-to-certain-node-identifier/15107>\
**Category:** XBee Programamble (S2C & 900 HP)\
**Tags:** xbee-pro-s2b, api-mode, node-identifier\
**Created:** [July 10, 2015, 11:58am UTC](https://forums.digi.com/t/api-tx-frame-to-certain-node-identifier/15107 "2015-07-10T11:58:56Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![davyvr](https://avatars.discourse-cdn.com/v4/letter/d/ecc23a/32.png) [@davyvr](https://forums.digi.com/u/davyvr)\
**Post date:** [July 10, 2015, 11:58am UTC](https://forums.digi.com/t/api-tx-frame-to-certain-node-identifier/15107/1 "2015-07-10T11:58:56Z")

</div>

Hello,

I want to create a network of XBee Pro S2B modules, which could be replaced when they are broken, so the only way I can see to uniquely identify them, even after replacement, is the Node Identifier. 64-bit addresses will change at replacement and 16-bit addresses are handed out by the coordinator and can not be set. (correct me if I’m wrong)

But then I am wondering, since I work in API mode (all error handling done by firmware so I want this), is it possible to create an API frame to transmit a certain piece of data to a certain node with known Node Identifier? If not, how can I know to which address I should send a certain package if I have for example 20 end devices and one of the XBees in them have been recplaced?

I want a maintenance technician to be able to replace the XBee without software reprogramming needed. At boot-up the Arduino to which it is connected can of course set al necessary settings correct, as long as they can be changed.

Kind regards,  
Davy Van Rossem

---

<div class="post-metadata">

**Author:** ![danielf](https://avatars.discourse-cdn.com/v4/letter/d/8baadc/32.png) [@danielf](https://forums.digi.com/u/danielf)\
**Post date:** [August 7, 2015, 9:52am UTC](https://forums.digi.com/t/api-tx-frame-to-certain-node-identifier/15107/2 "2015-08-07T09:52:47Z")

</div>

Check the document “90002173\_P\_900HP\_MODULE.pdf” on section “XBee-PRO 900HP link reliability”.

Regards,  
Daniel
