ATA1 and ATA2 commands return error on both end point and coordinator modules

XBee & XBee Gateway XBee - Zigbee
1

With the modules in AT command mode, most commands seem to work as documented but the A1 and A2 commands return error.

Modules… XBee Pro S2B Type=XBP24BZ7 FW=2870

I believe I need to force the modules not to attempt to use any other PAN ID in relation to another issue I’m having with EndPoint devices not reconnecting when the coordinator power cycles.

Why don’t the A1 and A2 commands work and how do I enable them?

2

Hi,

XBP24BZ7 (ZigBee) will not support ATA1 and ATA2 commands.
It will support AI(Association Indication) command.

Refer the product manual at the following link, http://ftp1.digi.com/support/documentation/90000976_G.pdf

Regards!