# Digi XStream Module-cannot enter into Command Mode

**URL:** <https://forums.digi.com/t/digi-xstream-module-cannot-enter-into-command-mode/15396>\
**Category:** XStream\
**Tags:** baud, xstream, command-response, xctu\
**Created:** [September 14, 2015, 10:37am UTC](https://forums.digi.com/t/digi-xstream-module-cannot-enter-into-command-mode/15396 "2015-09-14T10:37:17Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Rajendra\_Prasad](https://avatars.discourse-cdn.com/v4/letter/r/e9c0ed/32.png) [@Rajendra\_Prasad](https://forums.digi.com/u/Rajendra_Prasad)\
**Post date:** [September 14, 2015, 10:37am UTC](https://forums.digi.com/t/digi-xstream-module-cannot-enter-into-command-mode/15396/1 "2015-09-14T10:37:17Z")

</div>

we are using the below mentioned Digi XStream RF module

Part No:- X24-019NSI-RevB  
Quantity:-2 No’s  
Description:- 24XStream, 2.4GHz, 19200 Baud.

Among the two modules we have, one of the module is not working. The problem is when we try to enter into the Command Mode by issuing +++, it is sending … in response, but the expected response is OK.

We tested with all possibilities(with different Baud-Rates, with and without Hand-Shaking, with old and new XCTU). But no use.

What might be the issue?

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [September 14, 2015, 2:20pm UTC](https://forums.digi.com/t/digi-xstream-module-cannot-enter-into-command-mode/15396/2 "2015-09-14T14:20:57Z")

</div>

Either a baud rate or parity miss match. Try using the Restore function in XCTU to restore the radio to factory defaults. Also if you are using an XIB board, make sure that the switches are set for 1 on and the rest off.

---

<div class="post-metadata">

**Author:** ![Rajendra\_Prasad](https://avatars.discourse-cdn.com/v4/letter/r/e9c0ed/32.png) [@Rajendra\_Prasad](https://forums.digi.com/u/Rajendra_Prasad)\
**Post date:** [September 15, 2015, 8:44am UTC](https://forums.digi.com/t/digi-xstream-module-cannot-enter-into-command-mode/15396/3 "2015-09-15T08:44:44Z")

</div>

It worked well after restoring the firmware.
