# DigiMesh(firmware 804B) cannot be received.

**URL:** <https://forums.digi.com/t/digimesh-firmware-804b-cannot-be-received/1064>\
**Category:** XBee - DigiMesh\
**Created:** [October 27, 2009, 10:32am UTC](https://forums.digi.com/t/digimesh-firmware-804b-cannot-be-received/1064 "2009-10-27T10:32:25Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![baobao](https://avatars.discourse-cdn.com/v4/letter/b/35a633/32.png) [@baobao](https://forums.digi.com/u/baobao)\
**Post date:** [October 27, 2009, 10:32am UTC](https://forums.digi.com/t/digimesh-firmware-804b-cannot-be-received/1064/1 "2009-10-27T10:32:25Z")

</div>

In DigiMesh(firmware 8003), it was possible to send and receive it.  
But, it is not possible to receive it with firmware 804B.

Equipment A Equipment B  
(send) (receive NG)  
±-----+ ±-----+  
| XBee | ----------\> | XBee |  
±-----+ | ±-----+  
|  
|  
±-----+  
| XBee |  
±-----+  
X-CTU(monitor OK)

DigiMesh is a setting of default.  
When the application starts, CH, NN, and ID are set by the AT command. (don’t write)  
It was OK when reading it after it set it.

When CH, NN, and ID were set with X-CTU, XBee of equipment B was able to be received.

Why?

---

<div class="post-metadata">

**Author:** ![baobao](https://avatars.discourse-cdn.com/v4/letter/b/35a633/32.png) [@baobao](https://forums.digi.com/u/baobao)\
**Post date:** [October 27, 2009, 11:50am UTC](https://forums.digi.com/t/digimesh-firmware-804b-cannot-be-received/1064/2 "2009-10-27T11:50:23Z")

</div>

Hardware version is 1742.

---

<div class="post-metadata">

**Author:** ![baobao](https://avatars.discourse-cdn.com/v4/letter/b/35a633/32.png) [@baobao](https://forums.digi.com/u/baobao)\
**Post date:** [October 27, 2009, 12:47pm UTC](https://forums.digi.com/t/digimesh-firmware-804b-cannot-be-received/1064/3 "2009-10-27T12:47:45Z")

</div>

Additional information.

1. XBee(default)  
When the application starts, CH, NN, and ID are set by the AT command. (don’t write)  
It was OK when reading it after it set it.(A set value can be read.)  
—\>\> receive NG

2)XBee (CH is set with X-CTU).  
When the application starts, CH, NN, and ID are set by the AT command. (don’t write)  
It was OK when reading it after it set it. (A set value can be read.)  
—\>\> receive OK

Does it fail in the setting of CH?
