# end devices and coordinator XBee-Pro 802.15.4

**URL:** <https://forums.digi.com/t/end-devices-and-coordinator-xbee-pro-802-15-4/21339>\
**Category:** XBee - 802.15.4\
**Tags:** coordinator, xbee-pro, 4, 15, 802\
**Created:** [May 6, 2020, 9:07am UTC](https://forums.digi.com/t/end-devices-and-coordinator-xbee-pro-802-15-4/21339 "2020-05-06T09:07:06Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![markes51](https://avatars.discourse-cdn.com/v4/letter/m/c89c15/32.png) [@markes51](https://forums.digi.com/u/markes51)\
**Post date:** [May 6, 2020, 9:07am UTC](https://forums.digi.com/t/end-devices-and-coordinator-xbee-pro-802-15-4/21339/1 "2020-05-06T09:07:06Z")

</div>

Hello

I’m a newbee in this matter, and i have a basic question.( not to me…)  
I’m using 3 XBee-Pro 802.15.4 Modules

I will leave a xbee inside a room ( the end device n1 with a sensor in that only sendig data).  
In another room i will put the xbee coordinator

and , so far the coordinator I will put the other end xbee, only receiving the data from coordinator.  
I’ve atacched a picture of the schematic.

[https://ibb.co/nQJzNQY](https://ibb.co/nQJzNQY)  
Question:  
How is the configuration (ADDRESSES)of them??  
I dont like to use the number of each one- high and low ( maybe using a 16 bit address???)  
Before I look for help, I’ve tried a lot, without success.

thank you

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [May 6, 2020, 9:37am UTC](https://forums.digi.com/t/end-devices-and-coordinator-xbee-pro-802-15-4/21339/2 "2020-05-06T09:37:53Z")

</div>

Mark,

802.15.4 networks are not able to rout data. They can do point to point, point to multi-point or peer to peer.

For routing data like you have listed, you need to use a Mesh network as what is found in Zigbee or Digi Mesh.

Digi Support

---

<div class="post-metadata">

**Author:** ![markes51](https://avatars.discourse-cdn.com/v4/letter/m/c89c15/32.png) [@markes51](https://forums.digi.com/u/markes51)\
**Post date:** [May 7, 2020, 1:57pm UTC](https://forums.digi.com/t/end-devices-and-coordinator-xbee-pro-802-15-4/21339/3 "2020-05-07T13:57:34Z")

</div>

Thank you

As I said I’m not a expert in Xbee.  
Is possible I use a digimesh firmware in those Xbee…and get this feature??

Because now I’m using a 802.15.4 10ef firmware.  
and, if will be possible, what is the configuration?

Thank you, again