# How can I configure xbee s2 in point to multipoint network in AT command mode?

**URL:** <https://forums.digi.com/t/how-can-i-configure-xbee-s2-in-point-to-multipoint-network-in-at-command-mode/14993>\
**Category:** XBee - 802.15.4\
**Tags:** to, multipoint, at-commands, point, xbee\
**Created:** [June 17, 2015, 9:31am UTC](https://forums.digi.com/t/how-can-i-configure-xbee-s2-in-point-to-multipoint-network-in-at-command-mode/14993 "2015-06-17T09:31:00Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![sam](https://avatars.discourse-cdn.com/v4/letter/s/5f9b8f/32.png) [@sam](https://forums.digi.com/u/sam)\
**Post date:** [June 17, 2015, 9:31am UTC](https://forums.digi.com/t/how-can-i-configure-xbee-s2-in-point-to-multipoint-network-in-at-command-mode/14993/1 "2015-06-17T09:31:00Z")

</div>



---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [June 17, 2015, 10:54am UTC](https://forums.digi.com/t/how-can-i-configure-xbee-s2-in-point-to-multipoint-network-in-at-command-mode/14993/2 "2015-06-17T10:54:29Z")

</div>

That is the default configuration of the XBee ZB modules. That is to say, by default the coordinator will broadcast all data out to all other nodes within the network while all other nodes will be configured as a Unicast connection back to the Coordinator.
