# how to check the seller-node?

**URL:** <https://forums.digi.com/t/how-to-check-the-seller-node/13799>\
**Category:** XBee & XBee Gateway\
**Tags:** 900hp, arduino, reciever, uno, seller\
**Created:** [October 24, 2014, 8:10am UTC](https://forums.digi.com/t/how-to-check-the-seller-node/13799 "2014-10-24T08:10:46Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![victor75](https://avatars.discourse-cdn.com/v4/letter/v/e79b87/32.png) [@victor75](https://forums.digi.com/u/victor75)\
**Post date:** [October 24, 2014, 8:10am UTC](https://forums.digi.com/t/how-to-check-the-seller-node/13799/1 "2014-10-24T08:10:46Z")

</div>

Hello to everybody!

I have two modules XBee Pro 900HP S3B,  
and am triing to make a simple network with two nodes:  
seller and reciever (within one room).

My steps:

1. I loaded the firmware 8071 in module1(seller), set role “STANDARD ROUTER”,  
network ID = 1234, NI=comp1, Dl and DH - equal to SL and SH of module2  
(reciever).

2. I inserted module1 in IO Shield and then in Arduino UNO, which was earlier  
loaded with sketch, sending time 1 time per second. (Yellow Led on Arduino  
was blinking 1 time per second, then only little yellow “TX” was blinking on card  
IO Shield 1 time per second.) All this construction is connected to computer 1.

3. I loaded the firmware 8071 in module2(reciever), set role “STANDARD ROUTER”,  
network ID = 1234, NI=comp2. I have connected the module2 to computer 2.

Is it enough to see data from module1 in “Terminal”-window?  
I see nothing. (When I type “+++”, I see “OK”.)  
When I press to “Digi Device Discovery”, I see “No devices found”.

What I did wrong?

Is blinking of “TX” the proof that seller works?  
How I can be sure that seller works?

Thanks.

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [October 29, 2014, 2:13pm UTC](https://forums.digi.com/t/how-to-check-the-seller-node/13799/2 "2014-10-29T14:13:00Z")

</div>

The Digi device discovery is for our Ethernet based products only.

Try enabling API mode and then doing a Discover Nodes in XCTU. You should see both of them discovered.
