# network between  xBee-Znet and xBee-XB24

**URL:** <https://forums.digi.com/t/network-between-xbee-znet-and-xbee-xb24/2488>\
**Category:** XBee - Zigbee\
**Created:** [October 1, 2009, 8:10am UTC](https://forums.digi.com/t/network-between-xbee-znet-and-xbee-xb24/2488 "2009-10-01T08:10:16Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![drumanart](https://avatars.discourse-cdn.com/v4/letter/d/8baadc/32.png) [@drumanart](https://forums.digi.com/u/drumanart)\
**Post date:** [October 1, 2009, 8:10am UTC](https://forums.digi.com/t/network-between-xbee-znet-and-xbee-xb24/2488/1 "2009-10-01T08:10:16Z")

</div>

I have two xBee-XB24 and one xBee-ZNET 2.5. Is it possible to use the xBee-ZNET as a coordinator and the other two as routers or end-devices.  
And if yes, I need some help to configure the AT firmeware setup.  
Thanks a lot Martin

---

<div class="post-metadata">

**Author:** ![Admin1](https://avatars.discourse-cdn.com/v4/letter/a/bbce88/32.png) [@Admin1](https://forums.digi.com/u/Admin1)\
**Post date:** [October 1, 2009, 9:48pm UTC](https://forums.digi.com/t/network-between-xbee-znet-and-xbee-xb24/2488/2 "2009-10-01T21:48:10Z")

</div>

A ZNet 2.5 module’s part number would start in XB24-B or XBP24-B. An 802.15.4 module would start as XB24-A or XBP24-A.

In your post you said you have two XB24 and one XBee ZNet 2.5, so I’d say the answer to your question is no, unless all three modules are -B modules.

---

<div class="post-metadata">

**Author:** ![drumanart](https://avatars.discourse-cdn.com/v4/letter/d/8baadc/32.png) [@drumanart](https://forums.digi.com/u/drumanart)\
**Post date:** [October 2, 2009, 9:59am UTC](https://forums.digi.com/t/network-between-xbee-znet-and-xbee-xb24/2488/3 "2009-10-02T09:59:52Z")

</div>

Thanks for the fast reply.  
The “Function Set” of the X\_CTU prg. shows for two modules 802.15.4 and for one ZNET 2.5.  
So, the aswer is no.

Regards Martin
