# Newbie Simple Configuration Help

**URL:** <https://forums.digi.com/t/newbie-simple-configuration-help/541>\
**Category:** XBee - Zigbee\
**Created:** [March 10, 2010, 3:27pm UTC](https://forums.digi.com/t/newbie-simple-configuration-help/541 "2010-03-10T15:27:33Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![256mxr](https://avatars.discourse-cdn.com/v4/letter/2/2bfe46/32.png) [@256mxr](https://forums.digi.com/u/256mxr)\
**Post date:** [March 10, 2010, 3:27pm UTC](https://forums.digi.com/t/newbie-simple-configuration-help/541/1 "2010-03-10T15:27:33Z")

</div>

Hi.

I just have two series two modules and I need them on API mode. I need to send data from an analog input on my end device to my coordinator.

My firmware is 2964 on END\_DEVICE as ZIGBEE END DEVICE API.  
My firmware is 2164 on COORDINATOR as ZIGBEE COORDINATOR API.

This is my setup:

Coordinator:  
PAN ID:3332  
NI:COORDINATOR  
DH=0  
DL=FFFF  
AP=2

End Device:  
PAN ID:3332  
NI:END\_DEVICE\_1  
DH=0  
DL=0  
D0=2 //READ THE ANALOG SENSOR ON PIN 20  
IR=1388  
AP=2

Is this correct??? Is there something else I need to setup??? How can I test communication with X-CTU to confirm the link beetween them???

---

<div class="post-metadata">

**Author:** ![coez](https://avatars.discourse-cdn.com/v4/letter/c/aeb1de/32.png) [@coez](https://forums.digi.com/u/coez)\
**Post date:** [April 14, 2010, 1:25pm UTC](https://forums.digi.com/t/newbie-simple-configuration-help/541/2 "2010-04-14T13:25:16Z")

</div>

Hi  
Firmware ver looks right.  
AP=2 is a bit more difficult to use.Rather use AP=1  
use x-ctu terminal assemble packet as follow:  
Put display in hex. very important  
7E 00 0F 17 01 XX XX XX XX XX XX XX XX FF FE 02 49 53 CS  
XX= DESTINATION ADDRESS ALSO KNOWN AS DESTINATION SERIAL NUMBER.  
CS = CHECKSUM  
FF- (17+01+XX+XX+XX+XX+XX+XX+XX+XX +FF+FE+02+49+53)  
ONLY LAST TO BYTES.  
RESPONSE MUST BE SOMETHING LIKE THE FOLLOWING  
7E 00 15 97 01 XX XX XX XX XX XX XX XX XX XX 49 53 00 00 0000 02 03FF CS  
ITS IMPORTANT THAT AFTER 53 THERE MUST BE 00 = OK
