# No Rabbit Processor Detected

**URL:** <https://forums.digi.com/t/no-rabbit-processor-detected/9610>\
**Category:** Rabbit\
**Created:** [February 14, 2012, 3:40pm UTC](https://forums.digi.com/t/no-rabbit-processor-detected/9610 "2012-02-14T15:40:05Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![vitnekula](https://avatars.discourse-cdn.com/v4/letter/v/bbce88/32.png) [@vitnekula](https://forums.digi.com/u/vitnekula)\
**Post date:** [February 14, 2012, 3:40pm UTC](https://forums.digi.com/t/no-rabbit-processor-detected/9610/1 "2012-02-14T15:40:05Z")

</div>

Hello,  
I have development kit RabbitCore RCM5400W and Dynamic C 10.70. I connect this kit with programmable cable and with PC. Press “F9” and then “No Rabbit Processor Detected” appeared. Serial port is selected correct (I have only one COM1). Connector is also correct (I use “PROG”). Power is also correct (indication LED on the prototyping board). How should be Debug Baud Rate and Max Download Baud Rate setting?  
Thanks for any advice!

---

<div class="post-metadata">

**Author:** ![cpigilam](https://avatars.discourse-cdn.com/v4/letter/c/fbc32d/32.png) [@cpigilam](https://forums.digi.com/u/cpigilam)\
**Post date:** [February 17, 2012, 7:00am UTC](https://forums.digi.com/t/no-rabbit-processor-detected/9610/2 "2012-02-17T07:00:58Z")

</div>

Hello , see the section 2.3.1 Troubleshooting from the RCM5400W user’s manual from the link below

[http://ftp1.digi.com/support/documentation/0190169\_b.pdf](http://ftp1.digi.com/support/documentation/0190169_b.pdf)

---

<div class="post-metadata">

**Author:** ![vitnekula](https://avatars.discourse-cdn.com/v4/letter/v/bbce88/32.png) [@vitnekula](https://forums.digi.com/u/vitnekula)\
**Post date:** [February 19, 2012, 9:34pm UTC](https://forums.digi.com/t/no-rabbit-processor-detected/9610/3 "2012-02-19T21:34:17Z")

</div>

I checked all these problems, but no success ☹

---

<div class="post-metadata">

**Author:** ![stahta01](https://avatars.discourse-cdn.com/v4/letter/s/5f8ce5/32.png) [@stahta01](https://forums.digi.com/u/stahta01)\
**Post date:** [February 8, 2013, 6:55pm UTC](https://forums.digi.com/t/no-rabbit-processor-detected/9610/4 "2013-02-08T18:55:28Z")

</div>

I just had this issue myself; wasted an hour trying to find the cause. I changed the USB cable and it started to work.

Note: I had already tested the USB cable with another hardware device and it worked.

So, I suggest trying another USB cable even when you think the one you have works.

Tim S.