# Pullup resistor on pin 19 -\> digital input 01

**URL:** <https://forums.digi.com/t/pullup-resistor-on-pin-19-digital-input-01/1626>\
**Category:** XBee - 802.15.4\
**Created:** [January 19, 2011, 2:52pm UTC](https://forums.digi.com/t/pullup-resistor-on-pin-19-digital-input-01/1626 "2011-01-19T14:52:18Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![cioto](https://avatars.discourse-cdn.com/v4/letter/c/b782af/32.png) [@cioto](https://forums.digi.com/u/cioto)\
**Post date:** [January 19, 2011, 2:52pm UTC](https://forums.digi.com/t/pullup-resistor-on-pin-19-digital-input-01/1626/1 "2011-01-19T14:52:18Z")

</div>

Hello, I have one XBee that reads digital sensor data, and sends it to the receiver, and a 2nd xbee that directly (no serial involved) outputs this data.  
Reading (remote) and output (receiver) is done on pin 19, digital input 01 (output on the receiver).  
The problem is: I always read high level, even if the sensor is not connected on the transmitter. I only read low level if the sensor is connected and outputs low value, but with the sensor unplugged I read high, that is not ok for me.  
Maybe turning pullup resistor on on that pin could help?  
What’s the AT command for pin 19?  
Thanks so much.
