# Simulation of commissioning button.....

**URL:** <https://forums.digi.com/t/simulation-of-commissioning-button/17422>\
**Category:** XBee - DigiMesh\
**Tags:** xbee8\
**Created:** [September 20, 2016, 10:36am UTC](https://forums.digi.com/t/simulation-of-commissioning-button/17422 "2016-09-20T10:36:34Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![El\_Berto](https://avatars.discourse-cdn.com/v4/letter/e/bbce88/32.png) [@El\_Berto](https://forums.digi.com/u/El_Berto)\
**Post date:** [September 20, 2016, 10:36am UTC](https://forums.digi.com/t/simulation-of-commissioning-button/17422/1 "2016-09-20T10:36:34Z")

</div>

On XBIB-U-DEV board (using XB868LP) SW2 is “commissioning button”, so when I press it I’ll receive on remote modules NodeID and corresponding address.  
I’m trying to send AT commands instead pressing button:  
ATCB0, ATCB1, ATCB…, ATCB4

to simulate commissioning button.

1. why is there parameter range for 0 to 4 is there is only one commissioning button?
2. which parameter value should I use?
3. sending ATCBx using XCTU frame configurator I always receive “Status ok” answer, but in this case remote modules don’t give me any output message. What’s wrong?  
Thanks.

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [September 21, 2016, 8:50am UTC](https://forums.digi.com/t/simulation-of-commissioning-button/17422/2 "2016-09-21T08:50:06Z")

</div>

The correct values for the CB command is 1 - 4 which indicates how many times you hit or toggled the commissioning button.

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [September 21, 2016, 8:51am UTC](https://forums.digi.com/t/simulation-of-commissioning-button/17422/3 "2016-09-21T08:51:02Z")

</div>

Some of the commands or response values require the use of API mode. Such as network status.

---

<div class="post-metadata">

**Author:** ![El\_Berto](https://avatars.discourse-cdn.com/v4/letter/e/bbce88/32.png) [@El\_Berto](https://forums.digi.com/u/El_Berto)\
**Post date:** [September 21, 2016, 4:10pm UTC](https://forums.digi.com/t/simulation-of-commissioning-button/17422/4 "2016-09-21T16:10:46Z")

</div>

So it should be CB1, but no effects on remote node even if receiving “Status Ok” answer.