# the result of Association indication is  0x36

**URL:** <https://forums.digi.com/t/the-result-of-association-indication-is-0x36/366>\
**Category:** XBee - Zigbee\
**Created:** [November 15, 2011, 2:00pm UTC](https://forums.digi.com/t/the-result-of-association-indication-is-0x36/366 "2011-11-15T14:00:26Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![6162397](https://avatars.discourse-cdn.com/v4/letter/6/dfb087/32.png) [@6162397](https://forums.digi.com/u/6162397)\
**Post date:** [November 15, 2011, 2:00pm UTC](https://forums.digi.com/t/the-result-of-association-indication-is-0x36/366/1 "2011-11-15T14:00:26Z")

</div>

I have a connectportx2 and a Xbee-pro SE module(router).  
Both of them have test certificates.  
After I sent command CB2 to connectportx2 and sent CB1 to Xbee-pro SE module, the connectportx2 could find the router, but the result of AI command was always 0x36.  
Can someone help me?

---

<div class="post-metadata">

**Author:** ![shahrj1988](https://avatars.discourse-cdn.com/v4/letter/s/c4cdca/32.png) [@shahrj1988](https://forums.digi.com/u/shahrj1988)\
**Post date:** [December 3, 2011, 8:35am UTC](https://forums.digi.com/t/the-result-of-association-indication-is-0x36/366/2 "2011-12-03T08:35:41Z")

</div>

Hi,

I hope, the best way to make the test network and check is to use ‘in premise display’ software at the Xbee-pro s2b se side. And [iDigi-se.appoint.com](http://iDigi-se.appoint.com) to check the CPX2 gateways side communication.

No doubt ‘in Premise Display’ software is more often send automated commands. But you can see which API frames are being sent for learning and for making test network.