# Using XBee 868LP with Raspberry Pi2 and Windows 10 IoT

**URL:** <https://forums.digi.com/t/using-xbee-868lp-with-raspberry-pi2-and-windows-10-iot/15872>\
**Category:** Interface/Development Boards\
**Tags:** xbee-uart-arduino, raspberry-pi, xbee-868, windows-10, development\
**Created:** [December 1, 2015, 6:55pm UTC](https://forums.digi.com/t/using-xbee-868lp-with-raspberry-pi2-and-windows-10-iot/15872 "2015-12-01T18:55:42Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![delfo](https://avatars.discourse-cdn.com/v4/letter/d/9de053/32.png) [@delfo](https://forums.digi.com/u/delfo)\
**Post date:** [December 1, 2015, 6:55pm UTC](https://forums.digi.com/t/using-xbee-868lp-with-raspberry-pi2-and-windows-10-iot/15872/1 "2015-12-01T18:55:42Z")

</div>

Hi,  
i would like to use the boards that comes with the XBee 868LP Development Kit with the Raspberry Pi2 and Windows 10 IoT.  
Anyone has some experience on this configuration ?  
If there is not any drive for the Windows 10 IOT based RPi2 can i use the pin an UART to USB convert like the ZigBee adapter kit that works with the Zigbee 802.15.4 ?  
Thanks in advance

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [December 2, 2015, 8:45am UTC](https://forums.digi.com/t/using-xbee-868lp-with-raspberry-pi2-and-windows-10-iot/15872/2 "2015-12-02T08:45:50Z")

</div>

Digi uses an FTDI chip on the development board so I would check with [FTDICHIP.com](http://FTDICHIP.com) for your USB drivers.

If your Raspberry Pi2 has a 3V UART, then yes, you can just run jumper wires from it to the test points on the XBIB interface board.
