# XBee 900HP programmable - pull down & drive strength settings

**URL:** <https://forums.digi.com/t/xbee-900hp-programmable-pull-down-drive-strength-settings/21556>\
**Category:** XBee - DigiMesh\
**Tags:** xbee-programmable, xbee-pro-s3b, xbee-900hp, gpio\
**Created:** [July 15, 2020, 8:26am UTC](https://forums.digi.com/t/xbee-900hp-programmable-pull-down-drive-strength-settings/21556 "2020-07-15T08:26:33Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![D2K](https://avatars.discourse-cdn.com/v4/letter/d/f05b48/32.png) [@D2K](https://forums.digi.com/u/D2K)\
**Post date:** [July 15, 2020, 8:26am UTC](https://forums.digi.com/t/xbee-900hp-programmable-pull-down-drive-strength-settings/21556/1 "2020-07-15T08:26:33Z")

</div>

I am using the 900HP(programmable). How do I configure an input as a pull-down resistor in CodeWarrior/SDK? I seem to only be getting the choice of pull-up when I select my pin as an input under GPIO Type in the Smart Editor. I have PNP devices that source voltage to the input. I know this is less common than a pull-up, but just curious.

I don’t see anything in the documentation about this Pull-Down input capability, or what is meant by Drive Strength.

Thanks

---

<div class="post-metadata">

**Author:** ![D2K](https://avatars.discourse-cdn.com/v4/letter/d/f05b48/32.png) [@D2K](https://forums.digi.com/u/D2K)\
**Post date:** [July 22, 2020, 8:33am UTC](https://forums.digi.com/t/xbee-900hp-programmable-pull-down-drive-strength-settings/21556/2 "2020-07-22T08:33:00Z")

</div>

Just checking in on this one. I’m still not entirely sure what the approach is going to be here unless I can just override the value in code, which I have not yet tried to see what happens in the XML after doing so.
