# Xbee configuration in command line

**URL:** <https://forums.digi.com/t/xbee-configuration-in-command-line/18472>\
**Category:** XBee & XBee Gateway\
**Tags:** xbee-s2c-at, xbee, zigbee\
**Created:** [June 23, 2017, 8:30am UTC](https://forums.digi.com/t/xbee-configuration-in-command-line/18472 "2017-06-23T08:30:41Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![hari6493](https://avatars.discourse-cdn.com/v4/letter/h/9de053/32.png) [@hari6493](https://forums.digi.com/u/hari6493)\
**Post date:** [June 23, 2017, 8:30am UTC](https://forums.digi.com/t/xbee-configuration-in-command-line/18472/1 "2017-06-23T08:30:41Z")

</div>

Hi ,  
I am searching for any methods to configure XBee’s completely through command line in Rpi without any UI. Please suggest me some methods by which I can achieve my requirement.  
If any links available please mail to [harikrishnan641993@gmail.com](mailto:harikrishnan641993@gmail.com)

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [June 23, 2017, 8:45am UTC](https://forums.digi.com/t/xbee-configuration-in-command-line/18472/2 "2017-06-23T08:45:49Z")

</div>

Have you read over the command mode section of the manual? Any command you can issue via a web UI such as XCTU can be done by direct access to the UART and AT command mode.

That is:

+++  
ok  
ATID3, WR, CN  
OK

It is as simple as that.