# XBee-PRO XSC Kit?

**URL:** <https://forums.digi.com/t/xbee-pro-xsc-kit/2125>\
**Category:** XBee - Point-to-Point/Multi-Point\
**Created:** [December 8, 2012, 11:07pm UTC](https://forums.digi.com/t/xbee-pro-xsc-kit/2125 "2012-12-08T23:07:38Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![jjrr007](https://avatars.discourse-cdn.com/v4/letter/j/f07891/32.png) [@jjrr007](https://forums.digi.com/u/jjrr007)\
**Post date:** [December 8, 2012, 11:07pm UTC](https://forums.digi.com/t/xbee-pro-xsc-kit/2125/1 "2012-12-08T23:07:38Z")

</div>

I am trying to build a way to read water meters using radio communications only (not communicate by internet/cell). The meters would use the ones approved by Digi using the modules mentioned at:

[http://www.digi.com/support/kbase/kbaseresultdetl?id=3212](http://www.digi.com/support/kbase/kbaseresultdetl?id=3212)

The water meters mentioned in the above link use 900 mhz. Would the finally development kit shown below allow me to read these meters? The ability to send information to the water meter would be ideal, but not required.

[http://www.digi.com/products/wireless-wired-embedded-solutions/zigbee-rf-modules/point-multipoint-rfmodules/xbee-pro-xsc#overview](http://www.digi.com/products/wireless-wired-embedded-solutions/zigbee-rf-modules/point-multipoint-rfmodules/xbee-pro-xsc#overview)

It’s the XBee-PRO XSC S3B Development Kit.