# XBee S2C not receiving data

**URL:** <https://forums.digi.com/t/xbee-s2c-not-receiving-data/16712>\
**Category:** XBee & XBee Gateway\
**Tags:** xbee\
**Created:** [May 4, 2016, 1:01pm UTC](https://forums.digi.com/t/xbee-s2c-not-receiving-data/16712 "2016-05-04T13:01:04Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![lilyhack](https://avatars.discourse-cdn.com/v4/letter/l/13edae/32.png) [@lilyhack](https://forums.digi.com/u/lilyhack)\
**Post date:** [May 4, 2016, 1:01pm UTC](https://forums.digi.com/t/xbee-s2c-not-receiving-data/16712/1 "2016-05-04T13:01:04Z")

</div>

I am using two XBee s2c modules (from the Digi Zigbee Mesh kit). One of them is the coordinator and the other one is router. I am checking in XCTU if the data comms work

I see the router xbee never receives anything. It can send alright (data seen on the coordinator) but whenever I send from coordinator, the router module doesn’t receive it.

It works perfectly fine with a different XBee s2c module. So I guess the other one not working has gone bad?

I tried resetting firmware, upgrading firmware etc. Tried both in AT and AP mode but same issue.

I used below setting for the AT model

Coordinator  
PANID=2001  
DH=0  
DL=FFFF  
Coordinator Enable=1  
AP=2 (tried AP=0 too)

Router 1  
PANID=2001  
DH=0  
DL=0  
AP=2 (tried AP=0 too)  
Coordinator Enable=0

As mentioned earlier, if I change the Xbee router module to another module, it works. So is the not working one broken? Is there a way to fix it?

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [May 4, 2016, 1:49pm UTC](https://forums.digi.com/t/xbee-s2c-not-receiving-data/16712/2 "2016-05-04T13:49:32Z")

</div>

Try issuing a Local network reset on the router in question. That is an ATNR0. Along with an ATRE ATWR.