I’m using a Xbee PRO (XBP24 10ED).
I have to send a data message from an inertial sensor.

I’m working with Matlab\Simulink to do this.
I’m using a Serial Send block. (parameter set is: BoundRate 115200)

The problem is that when I turn on the Xbee, the refresh frequency of inertial sensor decreases.

The simulation mode is: Normal.
I read somewhere that the solution is to use Accelerator mode, but i can’t do this right now.

Can someone help me?


What is XBEE_SIMULINK? You might not find many people understanding your problem well enough to answer you.