# XBee ZB RF Data Rate vs. XBee ZB Data Throughput

**URL:** <https://forums.digi.com/t/xbee-zb-rf-data-rate-vs-xbee-zb-data-throughput/12748>\
**Category:** XBee Programamble (S2C & 900 HP)\
**Tags:** transfer-speed, throughtput, xbee\
**Created:** [March 31, 2014, 11:46am UTC](https://forums.digi.com/t/xbee-zb-rf-data-rate-vs-xbee-zb-data-throughput/12748 "2014-03-31T11:46:33Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![RSoukyZ](https://avatars.discourse-cdn.com/v4/letter/r/82dd89/32.png) [@RSoukyZ](https://forums.digi.com/u/RSoukyZ)\
**Post date:** [March 31, 2014, 11:46am UTC](https://forums.digi.com/t/xbee-zb-rf-data-rate-vs-xbee-zb-data-throughput/12748/1 "2014-03-31T11:46:33Z")

</div>

Hi everyone! I have had my first XBee modules (2 XBee ZB) since last week. I’ve been reading a lot to try to understand all the aspects need it too put them to work under the requirements of a project that I have. I haven’t found a clear response to a particular question and I hope you could help me.

1.- What’s the difference between RF Data Transfer and Data Throughput.

I also have a more specific question that could bring light to what I really want to know.

2.- Supposing I am working the modules in API mode. One of them is connected to a computer (Coordinator) and the other is connected to a micro-controller (Router/End Device). I am sampling with the micro-controller at certain speed and sending it via UART to the XBee Router/End Device. The specific frame type that I am using to send the data sampled is Transmit Request (Frame Type 0x10). If you look in the manual you’ll find that to send 2 bytes of data (10-bit samples), it is needed 17 bytes more of information: Start Delimiter (1 byte), Length (2 Bytes), …, Checksum (1 Byte). That’s information of interest to the programmer, but primarily to the XBee modules. The question is: Does Data Throughput (which is 35000 bps in XBee ZB modules) has to do with the amount of user data (10-bit samples in my example) that can be send, or the amount of user and machine data (the whole API packet) that can be send in practice?

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [May 5, 2014, 4:01pm UTC](https://forums.digi.com/t/xbee-zb-rf-data-rate-vs-xbee-zb-data-throughput/12748/2 "2014-05-05T16:01:44Z")

</div>

The RF data rate is a fixed data rate in which the radios talk to each other. Where as the throughput is the effective data rate after all over head is accounted for that I can stream data in from one COM port and out the other.
