# XMEM for Rabbit BL4S200 and xalloc / root2xmem / xmem2root

**URL:** <https://forums.digi.com/t/xmem-for-rabbit-bl4s200-and-xalloc-root2xmem-xmem2root/12190>\
**Category:** Rabbit Software\
**Tags:** xalloc, xalloc\_bb, bl4s200, xmem, rabbit\
**Created:** [November 15, 2013, 4:52pm UTC](https://forums.digi.com/t/xmem-for-rabbit-bl4s200-and-xalloc-root2xmem-xmem2root/12190 "2013-11-15T16:52:40Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![caarecengi](https://avatars.discourse-cdn.com/v4/letter/c/f0a364/32.png) [@caarecengi](https://forums.digi.com/u/caarecengi)\
**Post date:** [November 15, 2013, 4:52pm UTC](https://forums.digi.com/t/xmem-for-rabbit-bl4s200-and-xalloc-root2xmem-xmem2root/12190/1 "2013-11-15T16:52:40Z")

</div>

I have a production application that requires persistent storage. I have been using the bbram keyword, but my needs have changed and I wish to use xmem instead.

Presently, I have about a 16K struct that I am saving in persistent storage. I am putting in a “fencepost” (0xcaa93004 as the first and last 32-bit long’s) so I can tell if the area is “sane” or has been clobbered.

I used TN248 as a starting point. So here is the problem. For my production software, the memory gets clobbered whenever I power-cycle the Rabbit. If I use bbram keyword, it works fine, but if I use xmem if does not.

So I wrote a test program, reading and writing the exact same struct.

I use xalloc (type = XALLOC\_BB), xmem2root and root2xmem for allocating, reading and writing the data respectively.

The test program works PERFECTLY even after a power cycle. The production software does not.

Furthermore, when I check the pointer value returned from xalloc, the test program reports 0xc8b0, but the production software reports 0x59012.

However, these addresses ARE CONSISTENT through multiple power-cycles of the Rabbit board, so I’m thinking - who cares, as long as the address is consistent through multiple reboots.

I’m trying to make XMEM work reliably first. I have to then perform some refactoring as the area in persistent storage need to grow to about 32k, after which I can no longer shadow the entire block to processor RAM. I have to use the far\_memcpy to move sections of it at a time for my production application.

Questions:

1. Why is the memory getting over-written in one case and not in the other?
2. Instead of using xalloc to reserve the xmem and then shadow it to root memory? Is there a better way to just have this data fixed in xmem?

I can attach the test program but since it works, I’m not sure there is much point in that.

Thanks in advance
