# Xstream module setup

**URL:** <https://forums.digi.com/t/xstream-module-setup/2515>\
**Category:** XStream\
**Created:** [August 11, 2008, 3:13pm UTC](https://forums.digi.com/t/xstream-module-setup/2515 "2008-08-11T15:13:32Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![mb7700](https://avatars.discourse-cdn.com/v4/letter/m/ba8739/32.png) [@mb7700](https://forums.digi.com/u/mb7700)\
**Post date:** [August 11, 2008, 3:13pm UTC](https://forums.digi.com/t/xstream-module-setup/2515/1 "2008-08-11T15:13:32Z")

</div>

I have several x24-009nsc modules but not sure how to program these.

Do I need to get the development board and the xctu software?

Or is there a bare-bones setup I can use? Just connect to the serial port, supply +5v and then use the xctu?

I thought they were good to go out of the box – all I really need to do is set the baud rate to 1200 with 8N1.

I can see this forum gets little resopnse so if you do have an answer for me, I’m at [mringen@yahoo.com](mailto:mringen@yahoo.com)

THANKS KINDLY.

---

<div class="post-metadata">

**Author:** ![mvut](https://sea2.discourse-cdn.com/flex016/user_avatar/forums.digi.com/mvut/32/31_2.png) [@mvut](https://forums.digi.com/u/mvut)\
**Post date:** [May 5, 2014, 11:39am UTC](https://forums.digi.com/t/xstream-module-setup/2515/2 "2014-05-05T11:39:19Z")

</div>

These are 5V Connection, you need a level shifter in order to connect them to an RS232 port such as Digi’s XBIB-R RS232 interface board.
