# znet 2.5 in point to mutipoint setup

**URL:** <https://forums.digi.com/t/znet-2-5-in-point-to-mutipoint-setup/2363>\
**Category:** XBee - Zigbee\
**Created:** [April 1, 2010, 7:52pm UTC](https://forums.digi.com/t/znet-2-5-in-point-to-mutipoint-setup/2363 "2010-04-01T19:52:09Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![isaoz](https://avatars.discourse-cdn.com/v4/letter/i/e19b73/32.png) [@isaoz](https://forums.digi.com/u/isaoz)\
**Post date:** [April 1, 2010, 7:52pm UTC](https://forums.digi.com/t/znet-2-5-in-point-to-mutipoint-setup/2363/1 "2010-04-01T19:52:09Z")

</div>

Does anyone know if the xbee series 2 can be setup in point-to-multipoint configuration? If yes how? Can these modules be flashed with different firmware like 802.15.4 which is listed as capable of point-to-multipoint communication? Or is the 802.15.4 device completely different hardware?

---

<div class="post-metadata">

**Author:** ![Admin1](https://avatars.discourse-cdn.com/v4/letter/a/bbce88/32.png) [@Admin1](https://forums.digi.com/u/Admin1)\
**Post date:** [April 2, 2010, 8:24pm UTC](https://forums.digi.com/t/znet-2-5-in-point-to-mutipoint-setup/2363/2 "2010-04-02T20:24:23Z")

</div>

By default, ZNet 2.5 would be in a “point-to-multipoint” mode, since it supports mesh networking and is therefore setup to broadcast. If you’re referring to a more specific definition of the term, please let us know.

As for the other question, a series 2 XBee or XBee-PRO can only use the ZNet 2.5 or ZB firmwares. Only our series 1 radios can use 802.15.4 firmware.

---

<div class="post-metadata">

**Author:** ![isaoz](https://avatars.discourse-cdn.com/v4/letter/i/e19b73/32.png) [@isaoz](https://forums.digi.com/u/isaoz)\
**Post date:** [April 2, 2010, 9:55pm UTC](https://forums.digi.com/t/znet-2-5-in-point-to-mutipoint-setup/2363/3 "2010-04-02T21:55:50Z")

</div>

> As for the other question, a series 2 XBee or XBee-PRO can only use the ZNet 2.5 or ZB firmwares.

Is the ZB firmware the same as, for example, ZIGBEE COORDINATOR AT 1020 function listed for xb24-b in x-ctu software? If so, would that also be ‘point-to-multipoint’ by default. When you say it is ‘setup to broadcast’ , does that mean all end devices get the same data or can I selectively send data to a specifc end device in AT mode? I know this can be done in api mode.

Are the CTS RTS DTR flow control pins required for communication or can I leave them floating and select ‘none’ in flow control?
