# \#state

**URL:** https://forums.digi.com/tag/state/605.md

[Latest](https://forums.digi.com/latest.md) · [Categories](https://forums.digi.com/categories.md) · [Tags](https://forums.digi.com/tags.md)

---

## [read state of relay with xbee](https://forums.digi.com/t/read-state-of-relay-with-xbee/17318)

<div class="topic-metadata">

**Author:** [@chrisg1970](https://forums.digi.com/u/chrisg1970)\
**Replies:** 2\
**Last updated:** [August 31, 2016, 11:32pm UTC](https://forums.digi.com/t/read-state-of-relay-with-xbee/17318 "2016-08-31T23:32:30Z")

</div>

Hi I read lot of articles about how to control relays with xbee. In my case I want to control productiviy of industrial machine. Every time I produce one piece, a relay is open. I would like to check with xbee if rela…

---

## [change the state of gpios immediately without reboot](https://forums.digi.com/t/change-the-state-of-gpios-immediately-without-reboot/17073)

<div class="topic-metadata">

**Author:** [@m271828ngtao](https://forums.digi.com/u/m271828ngtao)\
**Replies:** 4\
**Last updated:** [August 5, 2016, 12:03am UTC](https://forums.digi.com/t/change-the-state-of-gpios-immediately-without-reboot/17073 "2016-08-05T00:03:00Z")

</div>

I have tried these commands for many times. What I confused is that after I enter the command ‘set gpio mode=output state=asserted’, the state of gpios do not change immediately. The state is initial state, only if you r…

---

## [change the gpio state immediately](https://forums.digi.com/t/change-the-gpio-state-immediately/17064)

<div class="topic-metadata">

**Author:** [@m271828ngtao](https://forums.digi.com/u/m271828ngtao)\
**Replies:** 1\
**Last updated:** [July 11, 2016, 6:02pm UTC](https://forums.digi.com/t/change-the-gpio-state-immediately/17064 "2016-07-11T18:02:35Z")

</div>

how can i change the state of gpio on digi connect me 9210 with plug N’play firmware immediately. I can change the initial state of gpio thru web interface, but if i want to change the state of them, how can i do? which …

---

## [XBee pin state override normal Din/Dout transmission?](https://forums.digi.com/t/xbee-pin-state-override-normal-din-dout-transmission/11677)

<div class="topic-metadata">

**Author:** [@helium](https://forums.digi.com/u/helium)\
**Replies:** 0\
**Last updated:** [July 2, 2013, 3:35pm UTC](https://forums.digi.com/t/xbee-pin-state-override-normal-din-dout-transmission/11677 "2013-07-02T15:35:31Z")

</div>

Hi, I have 2 XBees set up to communicate with each other, one connected to the computer and the other connected to an Arduino. The Arduino sends serial information to its XBee via the Din/Dout lines, and the XBee sends …