Dynamic C on non-Rabbit uC's ?

Being very new and green with Rabbit hardware and Dynamic C software, this may seem like a very naive question… but since I do not know the answer and would like the benefit of some experienced folks, here goes:

I see some very good features with Dynamic C, especially the co-statements used in multi-tasking, and was wondering if anyone has tried this software on different microprocessors.

The basic question is -
Has any one used Dynamic C software on non-Rabbit hardware (other microprocessors) ??

If so, what results/problems did you have (if any)??

Thanks.

Current Dynamic C versions are only written for Rabbit microcontrollers, there is no port to other processors. There are some very early versions of Dynamic C which support the Zilog Z-180 processor, but that is the extent of other processor support.