Possible to use (2) 1-Wire inputs (e.g. pins 17 & 18) on Xbee Pro 900HP?

When attempting to add a second 1-Wire Configuration in the Smart Editor, I get an error message stating “The selected component is marked as unique and there is already one component of this type in your project”.

Since the only hardware requirement to configure a 1-wire bus is a free GPIO pin, why is this not allowed?

Are you referring to connecting a 1 Wire Sensor or Device to the XBee module? I am referring to the products that are Manufactured by a company called 1 Wire.

I’m connecting Dallas one-wire temp sensors (DS18B20) to the radio. The only way to get it working was to manually edit the auto generated header files to allow for a secondary one-wire bus