Hi there
is it possible to toggle the GPIO pins of the DigiConnectME using SNMP?
Greets
Chris
Chris,
No it is not.
Cameron
I don’t see why not. If you can toggle them by software, then you can do everything you want. You have to write some MIBs and use SET commands to change the values of GPIO.
Adrian,
You have the proverbial nail right on the head.
The only reason that this does not work is lack of support within Digi’s SNMP MIBs.
For anyone who desire/need such a feature I encourage you to contact your Digi sales representative or support and make an official request for it.
I should clarify my original statement a bit, however. When I said that it was not supported I meant in respects to our Connect Integration Kit. If you are a development kit customer this is certainly possible, by the creation of your own MIBs.
Cameron