100msec Data Poll in Pin Sleep

XBee & XBee Gateway
,
1

Found following statement in the manual (Digi XBee® 3 Zigbee® RF Module):

“In pin sleep mode, the end device polls every 100 ms while the Sleep_RQ pin is de-asserted (low)”

Does that mean even when in sleep state, the End device can receive data from parent ?
If a remote AT command is issued, would the End device implement or entertain that ?

1 Like
2

No that is not what it means. What it means is that while the module is awake, it will pull its parent router once every 100ms for data. That data can be meant for the UART, a remote AT command, or any enabled ADC or DIO lines.

1 Like