ADC measuring in Digimesh firmware (3000) is not working.

Hi, I try to get data from adc pin (XBEE3) and I get only value 1023 regardless of voltage on that pin.


  1. I set up D2 pin to ADC measuring.
  2. Than I send AT command (IS) to get results and it return me always value 03FF.

When I do the same with Zigbee firmware I get normal values.

Is that bug in Digimesh firmware?

Thank’s god, i’ve got exactly the same problem !

Is the voltage on D2 under 1.2V ?

No, voltage was 2.5V

Well the datasheet says that the adc pin only accept voltage under 1.2V.
Did you find a solution ?