I asked this in another post got one answer did not work but no one else would reply. Does anyone have more info that could make this work?
Yes, this can be done by configuring a serial bridge.
On one unit (initiator), configure the following serial settings (example shows port 1):
Enable/Disable this port : Enable
RealPort support : Disable
Host mode : Terminal server
Port title :
Destination IP : (IP_of_other_Passport_unit)
Destination port (0-65535) : 7001
Protocol : Telnet
Serial port parameters : (Must match on both units)
On the other unit (receiver):
Enable/Disable this port : Enable
RealPort support : Disable
Host mode : Console server
Listening TCP port (1024-65535) : 7001
Protocol : Telnet
Automatic detection : Off
Port title :
Serial port parameters : (Must match on both units)
answered Mar 27, 2015 by userid0 Veteran of the Digi Community (1,710 points)