Problem category: XCTU
All Xbee were set to AP=2.
XCTU on MAC OSX 10.9.5
on Console, and frames are defined.
The frame generator automatically modified XBee address (high) from “0013A200” to “007D33A200”.
(1) click “Send a single frame” —> could send
(2) click “Start Sequence” —> error message “Could not send the frame > Special byte not escaped: 013x” was shown
Any suggestions are welcome.
Thank you.
cf) XCTU on Windows 8.1 works well for both cases.
against the same frames as above.
(3) click “Send a single frame” —> could send
(4) click “Start Sequence” —> could send