Ethernet communication problem

Rabbit
1

Hi All,

I am working on Rabbit 3400. I am trying to implement Ethernet communication using crossover cable(direct connection). Right now I am implementing simple PINGYOU.C & PINGME.C sample program but its not working. I have done following steps:

  1. Set the IP address of my PC to 10.10.6.100 & my board 10.10.6.101.
  2. Connected crossover cable between board & PC.
  3. LINK LED is glowing & even ACT LED is also blinking but everytime I am getting response timeout.
    I have checked the crossover cable but it is okay. Could you please guide me?

Thank you.
Rashmi