GRE configuration more than 2 tunnels - WR11

Digi TransPort WR (Series)
,
1

Dear all,

I’ve configured 2 GRE tunnels for 3 WR11 routers. However only the 1st tunnel works, the 2nd i can not ping between 2 LAN IP. I copy and paste the configuration from 1st to 2nd (of course i changed IP for connection only).

The configuration of tunnels are as below:

Tunnel 0: LAN IP of router: 192.168.1.2,
IP address: 10.10.10.1
Source IP address: 10.110.130.1
Destination IP address: 10.110.130.15

      LAN IP of router: 192.168.2.2, 
      IP address: 10.10.10.15
      Source IP address: 10.110.130.15
      Destination IP address: 10.110.130.1

Tunnel 1: LAN IP of router: 192.168.1.2,
IP address: 10.10.10.1
Source IP address: 10.110.130.1
Destination IP address: 10.110.130.2

      LAN IP of router: 192.168.3.2, 
      IP address: 10.10.10.2
      Source IP address: 10.110.130.2
      Destination IP address: 10.110.130.1

Could you please give me some hint for this issue?
Have i configured it correctly?

Thanks and Best Regards,
Dee

2

Hi, Did you determine what your problem was? Did you determine if the tunnel SA supports more than one subnet?