Help Help, PorServer2 16

Serial Servers & Infrastructure Mangement Portserver TS
1

Hi help,
I wantto use all ports on PortServer2 with 16 ports, Do I need to set a separet ipadress to each ports?

Thanks

2

No, you only need to assign one IP address to the unit itself and not the individual ports (although that can be done too).

How do you want to use the ports (COM or tty ports on host O.S., TCP socket, TCP tunnel, autotelnet, etc…)?

3

userid0
I Want to use AutoTelnet with Cisco Routers, how can I config it?

Message was edited by: londo4

Message was edited by: londo4

4

Sounds like you want to console manage the Routers. If so, the following document should be useful:

http://ftp.digi.com/support/techsupport/hardware/portserver/rtelnet.html

Also, you will need to use a special cable for connecting to Cisco Routers:

http://supportold.digi.com/support/techsupport/common/cables/async/rj45-8pin-altpin--cisco-rj45-8pin.htm

5

Thank, its works.
But now i got some question! my portserver works perfectly, I got two connections to the PortServr throu SecureCRT termina emulation to Pix Firewalls, How can disconnect the telnet sessions?

I try: quit, exit, Ctrl+[ non of those works. How can I disconnect telnet because I`m using SecureCRT terminal emulation?

Message was edited by: londo4

Message was edited by: londo4

6

You will want to use ] to break out of the telnet session.