How to configure DIGI EZ 4 for Ovation 4.0 Scada Protocol

Rabbit Rabbit Software
,
1

HI there.

I have the following questions regarding the configuration of a DIGI EZ 4 within an Ovation 4.0 communications DROP using the DNP3.0 Protocol Analyzer:

  1. How are the communication ports of a DIGI EZ 4 configured within an Ovation 4.0 communications DROP when using the DNP3.0 Protocol Analyzer?

  2. If TS MEI 4 is already installed and configured, and the communication ports are currently assigned and working, what considerations should be taken into account before adding a new DIGI EZ 4?

  3. What happens when Digi Navigator is installed and used to assign communication ports to a new DIGI EZ 4 while ports are already defined in Ovation/TS MEI 4?

  4. Can installing Digi Navigator or reassigning ports cause conflicts with existing port assignments in Ovation 4.0 or TS MEI 4?

  5. What is the recommended procedure to avoid communication conflicts when adding or configuring a new DIGI EZ 4 in this environment?

2

please try the EZ4 AI assistant: Digi AI Support Assistant | Digi International