how to configure XBEE to avoid the data collision

XBee & XBee Gateway
, , , ,
#1

Hello professors,

I am using XBEE to achieve the data transformation. I plan to use two routers and one coordinator. Each router will send the relevant data to the coordinator in a required time. Previously, I configured the XBEE both coordinator and router in X-CTU software.

My question is how can I configure XBEE to make sure that the XBEE has been set to the order of the avoidance of data collision? Is there any tutorial I can read or do you have some suggestion? I’m really appreciate your advice, Thanks again.

Best regards.

#2

The 802.15.4 protocol already has built-in mechanisms to avoid the problems caused by collision. If you are using multiple networks then make sure each separate network talks on a different channel. (CH)

1 Like