Hi.
I’m working with RCM5700 module.
The development module has the Ethernet connector 13F-61J, but I’m using the connector 12F-10D.
I know that the distribution of the their pins are different, so I developed the hardware to properly connect the RCM5700 module.
The problem is it doesn’t connected to the network.
I ping its IP address, but not responding.
In contrast, in the development module, the Module RCM5700 respondss the ping to its IP.
The hardware is properly designed.
The only thing different are these connectors.
Can this be the problem?
Fabián