Put Device Into MicroPython Mode

XBee & XBee Gateway XBee Micropython & IDE plugin
,
1

Hello All,

I recently received the XBee S2D ZigBee Mesh Kit and my intention is to use one coordinator attached to two end devices. Ideally as a small project I would like to send data from the coordinator to both of the end devices. Each end device should keep a count of data packets received. I wish to do this in MicroPython. However opening the XCTU application I can not find a way to place my devices into the MicroPython mode. In one of the documents it states that you need the XBDB or XBIB development kit.

Is there a way to use my XBee SMT Grove development board with the attaches XBee S2D module with MicroPython?

2

Hi,

XBee S2D does not support MicroPython. The only XBee models which have MicroPython are XBee Cellular, XBee 3 Cellular, and XBee 3 RF (Zigbee, DigiMesh, 802.15.4).

1 Like