Run only in debug mode

Rabbit
1

Hello,

I’m porting an old program from DC 10.21 to DC 10.72.
Currently I have only two lines in the applications: the BoardInit() call a
digital output. Then a for(;:wink: {}

If I enable the debug kernel I the led will turn on.
Otherwise it stays off.

I’m not sure what disabling the debug kernel does.
Do you have any idea about?
Perhaps it’s a known behavior and I didn’t searched well the docs.

Thanks

EDIT: I forgot to say I’m using a RCM4100 module

2

Hello , Post your code here , I will try to check it out.

Thanks.

3

I thank you very much for your interest. But The question was sent more than 3 month ago!