Set up of async term to interact with USB-ftdi adapter and xBee

XBee & XBee Gateway XBee - 802.15.4
, , , ,
1

I need to use AT commands over a USB-FTDI explorer to a xBee. I know the name, speed and so on.
Can anyone explain how to do it?
So far, I’ve used CoolTerm on OSX. I point CoolTerm to the right port, 9600, N, 8, 1.
I’ve assumed that I should issue the following:
+++ (alone without CR)
ATD1 2 + CR
ATWR + CR and so on

But I never have an OK after the three +s.
Anyone out there using this combination? Which parameters have you set?
Thanks, Elio

P.S.
XB24-API-001 rev.D
FCC ID OUR-XBEE
IC 4214A-XBEE

2

What is the exact part number of the xbee module you are working with?

3

XB24-API-001 rev.D
FCC ID OUR-XBEE
IC 4214A-XBEE

4

What happens when you use XCTU’s terminal function? Are you able to enter command mode or read the radio?

You mentioned using a USB connection? Who’s USB device are you using and how is the module connected to it?