XBee 900HP programmable - pull down & drive strength settings

[D2K]

I am using the 900HP(programmable). How do I configure an input as a pull-down resistor in CodeWarrior/SDK? I seem to only be getting the choice of pull-up when I select my pin as an input under GPIO Type in the Smart Editor. I have PNP devices that source voltage to the input. I know this is less common than a pull-up, but just curious.

I don’t see anything in the documentation about this Pull-Down input capability, or what is meant by Drive Strength.

Thanks

[D2K]

Just checking in on this one. I’m still not entirely sure what the approach is going to be here unless I can just override the value in code, which I have not yet tried to see what happens in the XML after doing so.