Greetings,
I am using the XBee-PRO 900HP RF Module and however, I am having issues communicating with the device. I do not get any response from any commands. I connected a digital serializer to see that I am indeed sending commands to Pin 3 (the UART input) at settings of 9600 Baud, No Parity, width 8, 1 stop bit. This module was taken right out of the box and inserted. Do I need to do any preconditioning? My reset line is at 2.4V does that satisfy the requirement for it to not be stuck in reset?
Any suggestions would be helpful!
Thanks!