Hello !
I’m a newbie. In my project I want to send data from Xbee S6B module to LAN. Where I can to get information about this ?
My regards,
Maxim
Hello !
I’m a newbie. In my project I want to send data from Xbee S6B module to LAN. Where I can to get information about this ?
My regards,
Maxim
Maxim,
I would suggest looking at XBee Wi-Fi RF Module User Guide
Specifically the Destination Address, destination port and source port.
Hello, mvut !
I’m started my project, but I connect Xbee to Nucleo-F411RE evaluation board, not to Arduino. How I can to configure my Xbee to connect to LAN in transparent mode ( by AT commands ), without XCTU ? My Xbee is responding well to AT commands…
I would suggest looking at XBee Wi-Fi RF Module User Guide
Good evening !
I try to configure my Xbee S6B and send “ATAI” command. And he is ansver to me by “41”. In the User Manual written that the module need to DHCP provided address. Where I can to take it ?
My regards,
Maxim
That would indicate that you would need to use the module in a location where you have a DHCP server enabled on your WIFI network.
Good evening !
I found info how to configure my Xbee to LAN in this link ( probably it’s will help to any user ).
https://learn.sparkfun.com/tutorials/internet-datalogging-with-arduino-and-xbee-wifi/all
And how I can to send “Hello, world !!!” string now ? How can I to make it ? What AT command is responsible for this ?
My regards,
Maxim
Good evening !
My Xbee S6B module connects to the client via WiFi, but does not even have time to receive a single message from it, immediately disconnects the connection.
Why does this happen? I tried changing the parameters SO, SP, ST but it doesn’t help. What should I do to keep the connection from disconnecting for at least two minutes?
And I don’t found NJ and SN parameters in my User Guide. What I can to use instead ?
I would suggest restoring to defaults. Then make your connection.