xbee to servo control board

So first off, I’m pretty new to the whole xbee and wireless integration. Just throwing that out there…

So I’m trying to interface the xbee pro 802.15.4 with a servo microcontroller in order to have wireless integration between the software and the physical board. I seem to have the hardware wired up properly as the servo board is getting powered while the xbee is wired into it.

The servo controller works on sending PWMs, I have been trying to use the ADC on the xbee via X-CTU but it does not seem to be working. I configured the transmitting module via the knowledge base, but it doesn’t seem to be transmitting.

Any help is well apreciated

What are you trying to do with the XBee and what is your result? Do you get an error? How did you configure things specifically?