Xbee3 reset to default values

XBee & XBee Gateway
, ,
1

I have a XBEE3 module in 802.15.4 mode and sometime the module resets to its defaults parameters.
I interface the module to uP using UART in transparent mode.

In firmware I don’t enter in command mode, i think is impossible that the module receive the ATRE command.

There is some hardware possibility to reset the module?

Thank’s

Daniele

2

Daniele, No, it does not have a hardware restore function but it does have a reset line that if triggered would power cycle the radio. So if your settings are not written to flash, that would restore it to default settings.