hello,
i’m trying to use AT V+ on a xbee3 digimesh 2.4 module to get/set the voltage supply threshold but always get an ERROR.
Firmware is 300B, xbee3 model XB3-24
Any ideas?
hello,
i’m trying to use AT V+ on a xbee3 digimesh 2.4 module to get/set the voltage supply threshold but always get an ERROR.
Firmware is 300B, xbee3 model XB3-24
Any ideas?
That is because the command is invalid. That is to say, per the manual, there is No V+ command for this product.
Ah, sorry, my mistake