Hi all,
I think I accidentally bricked my Xbee3
On the Dev board the user LED is always on. When going thru recovery mode it shows no bootloader found.
Any suggestions on what I can do to try to fix it or its done?
Thank you again Xbee community
Anthony
Be sure to try a different development board, possibly on a different computer (or try a good radio on your current computer and dev board) to check if the dev board and computer are working.
If you haven’t already, try XCTU recovery, it has a few ways into the bootloader.
Last, check the part number, if this is a “programmable” radio there are some additional steps you can try.
But if these steps don’t work the module may be bricked.