Digi WR11xt Default.asp's Default web port

Digi TransPort WR (Series)
1

What is the home web pages port number?
I assumed it would be port 80 but 192.168.1.1:80/default.asp does not load.
I need to change the default port because only ports 2000-4000 are open.
Is there a place in the settings where it’s listed and I can change it?

Thanks in advance

2

Hello,

Both HTTP and HTTPS are supported, you can enable/disable these two services in Configuration - Network > Network Services, if you’re in the webUI of the device.

On this device, HTTPS uses port 443, and HTTP uses both ports 80 and 8080.

To change 443 to something else, go to Configuration - Network > Advanced Network Settings.

I don’t think the HTTP ports can be changed.

3

Thank you for the information.

Something weird happens when I change the https port from 443 to 2212. The message when applying the setting says please wait when I click the save settings button and just sits there.

The service light changes to orange and just stays like that until I reboot. Then when I can login, it is still at port setting 443.

image001.jpg1874×1270 144 KB

Should I try to change any of the other settings for this area?

Thanks again for the assistance,

4

It wasn’t as straight-forward as I assumed. Once I selected default: ethernet and changed the port, then applied;

Yes, it would freeze on apply and never allow me to save, while also having a service light stuck yellow until hard reboot. But what I realized I could do was even though it wasn’t saved and would be lost on reboot. I able to log into a new tab via the new port, then reapply with the change already indicated and then save.

Then on soft reboot, the settings would stick and it the service light would no longer be stuck on yellow.

Cheers,

5

Thanks for the update. Am I correctly understanding that this request has been solved?